Recent content by aydyn

yes they do ..

Where do you live ? Michigan, Texas and a few other states have to pay 100% in full before the car can be brought in state even.

I find this hard to believe since it is only cars built after 8/5, what is your build date ? and i assume fremont ?

weird .. i've called about 15 shops in 3 states .. the cheapest i've found is 6400 for an xpel custom wrap (not using templates).

bcv

sent you a pm

What are you talking about? You want cruise control you’ve got it pull down oncelroblem solved. What are you complaining about ?

Anyone installed one ? The AP dash am quality is horrible just looking for tips to hardwire a thinkware cam

Yes and if you didn’t your seals would grow mold. How the service manager doesn’t know this is beyond me.

It’s a 10/10 in terms of difficulty good luck to uou

Visually it is tinted yes, but it has 0 cermaic/heat rejection capability. The 3 needs ceramic tint all around including windshield to be tolerable driving in the sunny states.

Never mind. Stupid design issue the clasp in the hpwc the wires go into is poorly designed it’s easier to have cables slip behind the clasp then in it.

Fairly simple setup. 60amp breaker, THHN #6 Red -> L1 on the HPWC 60 amp breaker, THHN #6 Black -> L2 on the HPWC <house groujnd> , copper bare -> copper ground on HPWC Flip on the breaker, no LED (yes the ribbon is connected) no red, no yellow, no green, nothing. Volt meter shows 120 between...

Lets be real however, given the actual amp draw never exceeds 48A, you will never cross the 60c temp rating of the NM-B 6/3. NM-B 6/3 is rated for up to 55amps, and that is continuous load not @ 80%. Everything with electrical code is over engineered, yes for good reason, but in an...

So something I was unaware of before, but my local tint shop is cautioning me that tinting everything including the front windshield could be problematic in the early morning due to LAH, an issue that he says effects all ceramic films. Thoughts?