Recent content by bluecow82

Sent you a PM.

22” Forged Turbine wheels in Onyx Black dressed in GoodYear Eagle F1 tires, staggered (22x9 265/35R22 and 22x10 285/35R22), with TPMS. Picked up on Friday, still in the bags, only took them out for photos. $5,000.00 Prefer local pickup in Los Angeles, CA.

If you are looking to buy and install the Tesla Model 3 Wheel Locks, know that the lug nut covers fit perfectly over the wheel locks (versus the MX wheel locks that can't fit a lug nut cover over them). Picture below.

Here's the picture I found (I believe on page 3 or 4 of this thread), with the partially removed panel.

Yeah, those panels. No sliding, just pull out firmly, but you start from the back of it and move your way toward the front. Somebody had a picture of them earlier in the post I believe, I'll see if I can find it and direct you to it.

Best to remove the black side panels, on both passenger and driver side. Those are easily removable, pull from the back (at end of the console), towards the front. It uses the same brass clips. Then it's just a pull uplike you said. I only removed the passanger side panel and I was fighting it a...

Blackvue has that option already, but it takes one hour to charge and lasts for 12 hours only. To a lot of people that's not enough, since their commute is shorter than an hour, and the car may stay parked at night longer than the 12 hours. Now, if there would be some sort of a switch that...

Not sure when I'll open it up again, but I'll remember to take photos of the actual connector next time. If I end up using that source of power, I was planning on tapping it on the wire directly, and running it thru a hole that I would have to drill on the same wall as the lighter socket. That...

Here is the underside of the keycard reader and the access to the back of the lighter socket, which makes it a pretty good place to grab 12V on the switched circuit.

Nice. That would make it so much cleaner. I need to check if that exists on the Model 3 somehwere.

Yeah, I looked into those. I actually had one in my Taurus way way back... They all seem bulky (not that I'm using that space for other stuff anyway). I thought I could get a "cleaner" looking install if I tap into a wire in the pasanger footwell.

Looking to eventually put in a Blackvue system, but I also want to install an LED strip kit, which I plan to take power from a switched source for. I don't want to occupy my 12V outlet with that, so looking for alternatives

What would be the right fuse for his install? I'm asking both for the direct to 12V battery connection, as well as for the switched connection.

Evening photoshoot.

Got these installed a couple weeks ago and like them so far: https://www.amazon.com/gp/product/B075M2RSNJ/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1