Recent content by cyin

Hopefully this bill will force Tesla to support drawing power from the car. https://www.mercurynews.com/2023/04/17/how-your-car-can-power-your-home/

Thanks Aggmeister I had pumped air compressor tank to 75 psi yesterday. Today it's around 135 psi. I think my compressor kicked off while driving or last night.

I have the red suspension icon showing up on my 2013 Model S P85+. It turns out my problem and solution is indicated on this thread: How I fixed my air suspension leak for $1.00

Thank you very much Johnr for the tip on fixing the hose I have 2013 Model S P85+ and I have the exact same problem. There is a dent and a pin hole as a result of rubbing against an electrical cable. I used JB Weld Epoxy and then once dried I wrapped with silicone fuse tape. Like Johnr I...

I'm writing my experience trying to hookup a Duracell 3000 Watt High Power Inverter to my 12v connector on Model S P85+ as an emergency power source and blowing 50amp fuse and adventure in repairing it. I hooked up 3000w inverter and 12v behind the nose cone. It did power up. I tried to power...

I had the same problem that "12v battery must be replaced soon" warning wouldn't go away on my Tesla Model X. I called Tesla support and they couldn't clear my error. Their soft or hard reset wouldn't work. They noted this on my service appointment. Luckily I read this post and changed wheel...

Thank you Grizz !! Your wheel configuration solution cleared my "12v battery must be replaced soon" warning after I replaced a new battery.

My Tesla Model S 2013 P85+ has the same clunking sound. My car has ~75k miles. It's noticeable when I accelerate from idle to ~10 mph or decelerate to stop. Tesla service finally fix the issue after three visit for the same issue. We could reproduce the issue by going to a parking lot, roll...

Do not use any Gorilla locks on your Tesla wheels! Be prepared to spend $$$ and effort to repair your lug bolts. I put 14m x 1.5 Gorilla Guard locks on my P85+ 21" wheels. I painted them black and I torqued them to 129 ft-lb. I didn't find any issue screwing the lock into the lug nut. A...