Recent content by Fady

Tell me about it!! Oh..I also forgot to mention. When I installed the new update, first thing I did was obviously plugging the charger in, 2mins later and I got the same error msg of charging speed reduced. I then did a hard restart on the charge (press the red reset button on the unit for...

Mine was fixed with the update - however, I happened to have an electrician booked on the same day I installed the update to fit an earth rod that the previous electrician didn't both installing (according to the wall charger user manual and the UK regulations, it's a must). I explained him the...

Ok - I’ve been told that at lot of model 3 owners are now experiencing this and it’s an old bug that crept back to the current firmware in the uk - it should get fixed on the 2020.28 version once it comes out.

Ok - a new update from Tesla - Apparently it's a software issue with the current firmware 2020.24.6.9. I've been told that this should resolve itself with the 24.8 version. No estimated time as to when this becomes available I thought I'd update the post here - in case you come across the same...

Thanks - I'll wait for their diagnosis to conclude and probably that's what I'll do eventually - They already have me booked for service in two weeks - but I don't think it's a car issue to begin with so I'm not sure how driving 100miles to get my car tested would help!

Thanks, Ravire - Yes I've come across this fault, but it seems related to Gen3 wall chargers, which is a smart charger with its own firmware. Sorry I should have mentioned I'm using a Gen2 wall charger as it's the only available model in the UK

Following a firmware update to 2020.24.6.9, I started to get an error message "Charging reduced - over heat detected at the wall connector". After plugging the car into the charger, it charges fine at 32A for 2-3mins then this message pops over, and the charging gets reduced to 16A (15mi/hr)...