Recent content by hmmwv

Quick update, the SC diagnosed the issue as caused by an improperly seated connector, no parts were replaced and the issues seem to have been resolved.

I might want to add I have three active alerts: VCRIGHT_a538_hvacSystemNotNominal -- this just means there is a fault in the system and made the climate keeper unavailable VCRIGHT_a271_THSSensorFault -- one or more sensors on the THS is reporting a fault, okay but it appears to me all the...

Just got the same error today in my March built MY, I noticed the automatic climate control hasn't been working the way I got used to, like very little cold air is coming from the front vents but rear seats are fine, had to turn on bioweapon defense mode to get the air really going. AC seems to...

Thanks a lot, got this done and it's a little scary as the whole panel kinda falls down on you, the screws are behind the grille so you'll have to remove the mesh grille first, but otherwise not terribly difficult. Now the subwoofer will be a challenger since I have a 7 seater so access will be...

I need to access the subwoofer enclosure in my 7 seater Model Y but discovered the 3rd row seaters appear to be blocking the passenger side panel that need to be removed. I've seen plenty of videos online to demonstrate how to access the woofer in a regular 5 seater, but nothing on the 7...

Did you install the two mid ranges in the rear trunk lid? If so is there an instruction or video for it? I wonder why they designed it to be used in the trunk lid vs rear doors, IIRC they are both plastic welded in place.

Thanks for the info, I did give it a try but didn't make any difference, so I'll schedule a service appointment. For my new MY I probably will ceramic coat the lens to keep it clear longer. One thing though since MY's camera sits higher it's far less likely to get muddy than my 3's.

Just found this thread, my Model 3 backup camera has very significant haze over the image that it's start to degrade the effectiveness (I need it to aim at certain marks on the floor to be able to park it at a tight spot). This is after cleaning it really well. Has anyone complained about this...

I'm looking at installing a cover over the license plate (not frame) but discovered that most came with screws that are too large for the four holes on the Tesla license plate backing. Anyone else have this issue? The Tesla supplied screws are simply too short to allow mounting of a cover over...

Yeah I ended up changing delivery center to Fife and took delivery there, it does have lower tax rates.

Agree with the above, you kinda have to have wait until the electric wine sound to finish and then push, but not wait too long. For me pushing the seat forward takes some force but the forward momentum is enough to initiate the tilting motion.

That's a good callout, I'll make sure not to use AP when I bring the vehicle back for service. I know right? It's so damn obvious that I'm surprised no one said anything, not just off the assembly line but at the delivery center!

Finally took delivery of my MYLR7, originally ordered in August and went through multiple holds, besides a few small issues the experience is good. The 3rd row is definitely cozy but works for our use case.

Just took delivery today of my MYLR7 and found a comical error by Tesla, apparently someone at Fremont forgot to install the internal trim piece inside the front Autopilot camera housing. It's also clear that zero QA check was done on the car as the issue is such a glaring mistake that you'll...

1. Model and Trim MYLR7 2. VIN 7SAYGAEE1PF711*** 3. Vehicle Build Date 03/23 4. Factory Freemont 5. Rear Motor 3D1