Recent content by IGW1

That turned out nice, I like the location of it. I had my 11 inch iPad mounted under the screen before and ran the TesLAX app on it.

He looked very sweaty when he got out, and his story of just zoning out didn't make a whole lot of sense with how hard he mashed the pedal, and he didn't brake at all. He did seem a bit impaired when we talked.

Yeah, just some minor back pain. I recline the back of my seat more than most people, so I'm guessing my seating position put more stress on my lower back than it normally would have. The motorcyclist did stop and make sure we were okay, it didn't look like anything hit him from what I could see...

The accident was at 5:35am. I'm guessing it was a long night of drinking, or he just starts really early.

Yeah, it opened up on the left just in time. A few hundred feet back and the lane was right next to a median. And the lack of traffic was really nice too.

On my way to work this morning when I was rear ended. I'm not sure what the difference in speed was, but I wasn't stopping or anything. I was going with the flow of traffic which was about 70 give or take. The other driver had to be going much faster to make everything in my car go flying around...

I was rear ended this morning on my way to work by a drunk driver. I got the same page but didn't think to take a picture of it. It appeared right after he hit me and my hazards automatically came on.

https://www.amazon.com/dp/B07D1BY5C9/ref=cm_sw_r_cp_apa_i_26e6Eb6J7C8FG

That's good to know, thanks for mentioning it. Do you remember the dimensions of the wheel that you had it mounted on and the offset?

The ones I've seen running it didn't have a problem. Obviously with aftermarket wheels and the right offset though. I think with my 35 offset would clear it no problem. I think I have room to spare. It would be 9.25mm added to sidewall height from my setup, but narrower tread by 10mm. I'll have...

Here's my dual motor with 19X9.5 wheels and 265/35/19 tires before I lowered it. I saw a few pictures of guys running 255/40/19s, and I think they'll fill in the fender gap a bit more and look better without it being lowered. And they'll give you a little more tire for a softer ride. I might try...

Here are a few pictures of how the mounts are attached and the USB hub I'm using. The passenger phone mount is just a Scosche magnet stuck to a mount that I 3D printed. I also placed a 2 tiny sections of weather-strip on the 2 bottom tabs of the tablet mount to keep it from scratching the center...

My last phone/phablet (Note 9) didn’t fit in the OEM tray in the center console, so I removed the tray because it was just in the way. I always make sure that every modification I do can be easily restored back to the original condition, because I hate having non-OEM holes left in dash and body...

Here's my solution. Using Samsung Dex on my Note 10+. I just plug my phone into the USB like I'm charging it and throw it in the mount. I have full control of my phone and all apps in a desktop format on the 13.3" touchscreen monitor. I don't feel bad leaving the monitor in there 24/7 and...