ilovecoffee
Member From Mississauga, Canada
Latest activity Postings About
-
-
ilovecoffee replied to the thread Ear pain/Pressure help.100% I get the dread. It can be solved though it just depends on how far down the rabbit hole you want to go. You don't need to remove... -
ilovecoffee replied to the thread Ear pain/Pressure help.The paper won't be held in by just the gasket itself, that's normal. You can add additional rubber seal, I can't say for sure it will...
-
Ok, here another update: I found a reasonable way to mount the BMW tuned mass damper in the trunk door. I had to cut off the original...
-
In my next step I proceeded with deadening the rear doors, in the same way as I did the front doors. The difference this time is that I...
-
Small update: I continued this quest by further treating the front wheel wells. I didn't go overboard with the alubutyl here, only...
-
I don't think heating is a good solution if you want to keep the tube pliable also in use. It'll be rigid again when cooled down. I also...
-
ilovecoffee replied to the thread 2023 Model Y Long Range Disappointment in boominess after Demo Drive.To me it looks significantly louder with it closed. That band is quite a lot brighter. I'd still do vinyl tubing in the gasket and...
-
ilovecoffee replied to the thread Ear pain/Pressure help.Most can only record down to ~45hz and these tones are around 30 to 40hz
-
ilovecoffee replied to the thread Ear pain/Pressure help.You won't make the seal worse. It's unlikely you will make the noise worse if you do it properly and take your time. It's easy to pull...
-
ilovecoffee replied to the thread Album / Audio Art Disappeared.With Spotify? With the new Spotify refresh update? I'm no longer having this issue. Sometimes it's slow to load but I figured because...
-
Quick update: I installed vinyl tubing and I measured 5-10dB reduction in noise at 20-35Hz area. I could also hear the change. Awesome top!
-
ilovecoffee replied to the thread MYLR7 Sound Deadening.Ah ok, interesting to know. I'm in Canada so similar weather conditions. I may do the exterior of the wheel wells as well. Regarding...
-
ilovecoffee replied to the thread MYLR7 Sound Deadening.Wow that's quite the undertaking. Good job. If it were me I wouldn't focus on the doors. The resonance in this car I feel all starts at...
-
I chose to use this old thread since my case is close enough. Also my plan was to reduce annoying road/tire noise in my MYLR -22 cabin...
-
Here are the measurements before and after. I used Room EQ Wizard + UMIK-1 + laptop for measurements. The microphone is calibrated but...
-
-
Loading…
-
Loading…
