Recent content by jaysen

Free Unlimited supercharging included/transferable?

I'm away from my tablet which is the device I took the photo on... I'll try and post when I get to it. But basically it is a legal size paper with a pre-printed grid of one inch by one inch squares. The installation team places a sticker in each grid as they install a panel. Unfortunately they...

Here are the rates for the TOU plan I am on.

Brett, Thanks for the reply. Yes I am on NEM 2.0 with SCE- TOUD-4-9PM Unless, I looked at the chart wrong... the most expensive time to use power is between 4-9p which solar production has already begun to taper off. Everything else is .33cents/ kWh So in a perfect world, like you mentioned...

So, FINALLY had a full weeks production after they came out and fixed my panels... I've requested solaredge monitoring, but this will have to do for now. Viewing my screenshots, would one say this is on par with absolutely no shading and mostly ideal sun coverage on a south facing roof? Also...

Here is my one full-day production for the section that was "fixed" - kinda difficult to figure out how many panels are producing, since I have 3 arrays? Total of:1 1.6kWh Anyone wanna take a shot?

So whatever re-wiring the two electricians did, I was able to produce 2.8kwh from about 1pm to Sundown

Dave, I wasn't home, but briefly heard the conversation the tech had with my wife via our doorbell camera. Apparently they "tried" to rewire as much as possible but when they realized it was all wrong, they stopped and claimed they needed the original installation crew to come out. As I...

Well, bad news on top of more bad news... The two technicians came out and stated there was some wiring issues with the j box and some of the panels. Apparently these two techs were able to rewire it somewhat to at least produce something in the interim... Ughh estimated time frame is 1 or 2...

Not home at the moment to test what Dave recommends, but called Tesla anyways. They'll be out tomorrow to check things out

Meh, not the update I wanted to give... Still no production, Tesla tech support had me power cycle with no luck. Need to call back Just out of curiosity, would adding my own ethernet wire cause the app to not update, and show no production? Aa mentioned I can see consumption in the Tesla app...

Haven't been following your issue, but as you can see these new inverters have the "P 1 (or I) O" positions so kinda confusing... *IF* my installers left it on 1 (or I) then I must have hit, and shifted it, when I was routing my CAt6 cable from the ethernet port into the garage.

Doh I'm an idiot - guess it's deserved!

@BrettS Good observation, I found this link on solaredge website explaining the position my switch was in. Looks like the inverter was off based off of the switch orientation.... Inverter Status and System Performance Indications | SolarEdge US Now that the dang sun is down, I'll have to...

Dave, correct... That is the same LED I am referring to. @BrettS - according to the manual that is the actual inverter power switch. I imagine if the switch was in the incorrect position I would not get any LEDs at all? I will try cycling that as well. Unfortunately, sun is going down now so...