Recent content by Jbrandon2002

I have had my MX now for about 1.5 months and already have over 5k miles on it. Since delivery one of the FWD has made a small plastic popping noise most times when opened fully or closed. I had service look at it and they said they adjusted the plastic and it shouldn't happen any more. Since...

I am sure part of it has to do with the fact that somehow after I placed my order July 23rd the DS that no longer works at tesla managed to switch my delivery request from soonest to December...which I only caught because after weeks I still hadn't seen a vin..so I had to start calling to find...

While I know you are correct it is very difficult to just sit back and wait without some kind of answer. I am located in Kansas and unfortunately the DS for my local service center is no longer working for tesla and the DS for St Louis is so overworked that I can't seem to get any response from...

So I ordered my Model x back in July and got a production completed email on September 21st. Since then nothing has happened according to my tesla contact (DS is so overwhelmed that I am having to work with the retail store manager for delivery info) my vehicle has not moved since it finished...

I think your video just saved me...I am an idiot and was not connecting the front panel with the ribbon cable...I kept looking at that ribbon and had convinced myself it must be for some kind of diagnosis device or something...while I was watching your video I noticed that there was actually a...

Actually it is funny you ask that...I started off with the ground connected to neutral because in most situations that would be ok...however I reviewed the docs and the picture shown has the green #4 ground connected to the bare aluminum ground. I moved it from the neutral to the ground bar. I...

No discount..I bought with the plan to ultimately have two eventually and they can run off the same breaker.

I will check that out ..the 30 amp is a small mini split AC that I just installed in the garage. How can I I check that the ground bar is grounded properly...since this is a sub panel I know the neutral bar has to be isolated from the ground which it is...you can see the large bare ground...

Checked and rechecked the dip switches. Switch one is off and switch 2 is on. Some I have 240v service.

The issue is that there is no pattern. The timing of the blinking is consistent and there are no gaps. Thanks.

I am in the process of getting everything ready for my upcoming model x delivery. I just installed my HPWC. The unit is installed off of a newly installed 100 amp sub panel in my garage. I am currently only using a 60 amp breaker to the HPWC. However I have run into an issue. The HPWC will not...