Recent content by Matte3

https://dmv2u.oregon.gov/eServices/_/#1 If the link makes you "start over", its the 3rd option down from the "registration" tab which is located in the center of the page towards the top..

Can you send me a private message? I can't seem to find out how..

Could you send me a private message? Can’t seem to figure out how.

You just need 1/2" on the sides. I use a 1" roll and cut it in half after cutting the entire length I need and use each half for each side. Hope that makes sense.

We do a lot of XPEL wraps at my shop and so we need to remove the factory spoiler quiet often and install it back on after the wrap. I have not seen one factory installed one that sits nice and flush against the trunk. The ends are always lifted. We remove the factory double sided tape and...

Yes, the aligned it as well. They also installed new tires and wheels for me. I understand the drive, but since they are experienced on these cars and specialize in race car suspension on a daily basis, I wouldn't trust anyone else with it.

I recommend AR Motorsports in Tigard, OR. They lowered my 3 on Motion Control Suspension

Yes, it is very similar to nardo gray. We wrapped it and also applied XPEL PPF on the full front and rockers to preserve the wrap against rock chips damage!

Thank you!

Lowered on Motion Control Suspension (MCS)

If you really want to see if its aligned straight on the hood or not, open the frunk and eye the line of the emblem to the latch!

I have the same issue, been meaning to ask service about it.

Can you send me a message with your contact number? I can't seem to figure out how to send a message. Thanks