You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
Just buy the Torx bit and you can usually move that little U latch on the body 2mm or so with out issue. I adjusted mine with no issue. Then you can take your time and make it perfect.
How did the bear manage to sneak out onto the road with out you noticing? I know that deer and etc will dart out in front quickly and unexpectedly, didn't think bears do that...?
I’m also 6ft 4in. You should be good. It is a little low which could pose a challenge to get into if your tall and on the heavy side (squatting pretty deep to come down from 6+ ft). Should be similar to your Pontiac in that regard tho. Once in, no problem. Plenty of room on both sides, there is...
The devil is in the details. Now EAP features are considered FSD features. So yes this hardware can do FSD, but not fully. And future iterations unlikely. Will they say “well you were able to do FSD features, just not everything that HW3.0 can do, etc”.
Where in Cali are you? If in the northern Los Angeles area I can recommend a few folks. Just send me a message.
I only have 125amps in townhome. I had to have my panel swapped out because I ran out of slots (and all breakers were already half width). Then they ran 6# through wall about 10-15...
Is the paint layer actually removed? Or just some of the clear coat? I’d suggest trying a well reviewed paintless dent repair. They may be able to remove the dent and wet sand the scratch for a reasonable cost. If you paint it you are probably looking at over 500.