Recent content by mstatkus

Thanks for posting this. I hurt my quads on my left leg and kept adjusting my rear end in the seat. I guess thru doing that my back popped the one on the left side free then squeaked. It’s also interesting seeing people complain about the seat bolsters. My exp. has been if it hurts you have a...

Mine just did this, I feel like it’s a bad cloud profile sync now as both my cars show 0 recents and 0 favorites. I’ll put a comment in my existing service ticket as my tow mode is missing with my installed hitch too.

I’ve had it happen even with my Hankook 12V LA battery. Screen goes black or hard reboot. Like 5 full minutes until the car reboots. Also did it with ohmmu. Even had audio crackle a little too. It’s an odd one.

I think it’s toast. Bluetooth UART just lets you connect but the underlying bits don’t respond or take a flash. JBA routes you to Ohmmu. I didn’t get a response. Also interesting anyone with that software could basically flash your battery in the wild.

Sounds like I got this JBA bluetooth module at the mailbox so I’ll try to pick it up tomorrow and see if I can recover my v4+.

So 14 degrees with the lead acid. Barely could open my power frunk. It could not close it. I had to reset the latch and push it down manually. In similar fashion my trunk so slow it sounded like slow motion. But did not open all the way. So I had to ponder if this is a sign the powered...

I had this happen in my MYLR early on. I actually made the seat slide all the way back, then reset to my profile and it went away 🤷‍♂️. Its a odd one.

Yeah that works.. was able to compare the serial 16930001 to the right PDF. Looks like heating function in charging state is turned on at 32F and off at off at 41F. The heating (pad) not connected as mine is older. Notes on freezing temps - 4.5.2. Charge and discharge low temperature...

Cool thanks. Adding link here Ohmmu | BMS Firmware Updates - Google Drive Occurred to me to the way this works someone could flash your battery remotely too heh. I'm still trying to figure out if that bin file flashes the bluetooth module or the actual BMS itself. JBD doesn't have much on...

Watching these I even get the feeling many get the programming wrong. I didn’t need a multi tool to pop the top heh. It actually broke free pretty easy.

Looks like I need a UART interface to maybe save the firmware. Also this appears to be a 100A model and gauge wire inside I wouldn’t push it past that.

I’m going inside my v4+. BMS: JBD Smart BMS 4S 100A 150A with Built-in Blutooth, Heating function or Switch function Support Series Connection freeshipping - Jiabaida BMS

Yeah it’s probably toast. Suspect it requires disassembly and hard lines to save it now.

Think that TeLink OTA bricked my v4+. Haven’t seen it show up on Bluetooth for a hour now.

Did you have to buy another heated one or did Sean send that out?