Recent content by noguchi

Thank you for your comment. Two new fan motors have been replaced, and the PEM and motor cables will be replaced with new ones. Ichecked, but there is no burn on the connector on the fan motor side

Hello, please tell me. I installed it yesterday, I still get a PEM fan motor error display ... I can't charge it. PEM fan immobility when 100V and 200V charging, unchargeable error, new fan replacement, DC12V energized directly from the fan connector, fan turns. PEM connector replaced...

hello. I need a PEM board wiring diagram, does anyone have one? please let me know. Noguchi.

Thank you for your comment. I checked the microswitch. No problem.

Hello. Does anyone have a wiring diagram of PEM?

Not rechargeable, 100V, 200V, red light Unable to drive, error display ID901, ID1144, meter red Fault disappointing… The PEM connector was remade and installed, and the other three connectors were also cleaned and contacted with grease. Battery storage mode, charger 100V connection...

Thank you for your comment. Check the wiring of the PEM connector again. When it can't be improved, switch the battery to save mode, hibernate, and wait for Tesla SC's home repair mobile service. Thank you Noguchi.

こんにちは。 誰かに教えてもらいたいです。PEMコネクタを交換した後、エラーアラートが表示され、実行できなくなり、充電されなくなりました。 温度表示はありません。赤いID901とID920のエラー表示があります。 のぐち。

The thermometer, motor, PEM, and battery are displayed.

Hello. Please tell me which part of the sensor it is. Noguchi.

PEM Rebuilt noguchi.

After PEM rebuild, VDS error display, error code ID1074, DMC FW: PhaseA Temp Diff warning ID1076. DMC FW: PhaseB Temp Diff warning Please tell me how to repair. We apologize for the trouble. Noguchi.

Hello. Can I use chademo with loadster charging with these connectors? Use is in Japan. Please tell me how to do it. There are a lot of jdemo communication errors these days... Noguchi.

thank you. Where is the motor output current line color of the CAN bus and the line color when the power is on? Please tell me if you understand. Noguchi.

Hello. The VDS and meter that removed the OVMS from the CAN connector were displayed correctly. OVMS was faulty. Noguchi.