Recent content by realrift

Hi, the mic problem seemed to be because I plugged in the right sided 2-pin connector into the left side and vice versa. When I swapped them over the mic worked again but I personally didn't have the left door/mirror tweeter working. The right door tweeter worked. This may just have been my...

Thank you for the info. I might change both tweeters to the same value at some stage. I believe the 4.7uF will give a higher crossover point than 470uF. I found a chart yesterday (which I can't easily find again today) with capacitors values vs crossover frequency for set impedence values. I...

I ended up tapping a signal from the left pillar speaker and running that to the purple/black left door tweeter wire. Used a 4.7uF electrolytic capacitor in parallel to the tweeter as a crude high pass filter. (Not sure what values the capacitors are in the box the cable connects to). The left...

I just tried swapping the 2-pin cables from left to right side. It was a very tight fit, with the cables barely making it from side to side under the carpet. So now the left side has the 2-pin (purple wires into factory purple/black plug socket)) and the right side has 2-pin (green wires into...

Yes, I connected the small plug on drivers side to the unused socked. I am now just wondering, as the small plugs are the same size and shape, could they be plugged into the wrong side (ie left swapped with right)?

Hello, I have found that if I disconnect the purple/black 2-pin wire (under the dash on the left) and plug in the 2-pin wire from your cable then I lose the mic. If I connect your kit but leave out the 2-pin wire (ie leave the factory purple/black in place) then the mic works and the 4...

Hi all, I have recently purchased a DIY Audio Upgrade kit for my 2019 Australian right hand drive Model 3 SR+. I have installed the audio cables and box yesterday. The sound was good and all 6 of my extra speakers seem to be working. Unfortunately after the install my microphone is not working...