Recent content by turbosetch

SOLD. Thanks everyone for looking.

I was looking at the options and also forgot to mention the car has dual chargers and with the wall charger I have you can do a full 80 amps.

Build date is 12/14. It has the cold weather package, but it does not have the heated steering wheel. Attaching screen shot drive modes here.

2014 Tesla Model S P85DL 77k Miles I am selling my Tesla because I work from home now and no longer need this car. I just got it back from the Tesla service center with a 100% clean bill of health and all updates done. The center screen was also just replaced with the updated one. It does...

Covered under warranty, no charge.

Just for reference my 2014 MS p85d MCU1 AP1 died while still under extended service agreement. Tesla came out and replaced it with an MCU2 last week.

There is a service bulletin for this. Could be mounts or a cv axle. If you have air suspension raise it up and if it gets worse that tends to be the axle. I have had my axles replace 3 times now for the same issue.

This is a simple fix. Just pull the panels out of the frunk and spray the joints with wd40 or pb blaster on the steering shaft with the ujoints. As your spray have someone turn the wheel. Wait about 30 mins and spray again. Let it sit over night and by morning it will be smooth as silk. ;)

Epoch Converter - Unix Timestamp Converter

Thanks I noticed this when it was posted there. That site is great, we just need more people to contribute. Now if someone knows how to get their hands on away to change the firmware for BMS that would be great for those playing with different battery packs and BMS boards.

You probably need to match the pack config number to the battery and the original BMS. You will need root access to do it.

The firmware is already on the car. When you do a deploy as described it will check to see what you have and install what you need or are configured for. Although I think waiting for a software update may do the same thing...its a good question and someone with more experience with this may...

Just a bit more input here. I have had the same sort of issues with the factory-redeploy. I have found the consistent way to make it work properly is to get connected but before you issue the command use the MCU to turn the power off then run the command. The car will then turn on and off a few...

No takers huh?

There are actually a lot I want to understand better. I have been collecting different configurations that I know the options on to basically translate. For instance: performanceaddon - what are the options airsuspension 2 - definitions of different numbers performance 2 - definitions of...