You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
I think you are right with the loop bit, bad axle makes more vibration, under load old soft bushing cannot damp it so the axle getting worse, new bushing mitigate that to some extent, but at the point people complain about the vibration its too late to just change the bushing so new axles is a must.
Each rubber bit in the bushings has numbers on them like +17 etc, I think thats stiffness. For reference look at the image, thats the old revision driver side motor mount for pre lift S. It has values between +15 and +17, whereas new revision has +21 to +22.
Ok so I had a little thinking about this. I do think the issue must be coming from the fact that the axles are just making non centric rotations thus causing little vibrations, they are unnoticeable and just damped when the bushing are within their working area, but as soon as I hit hard on the...
Thats what I did, check out Vibration on hard acceleration where you can find the video from inside, its not plaid but the mechanics are most likely the same. The thing I suspect which is also kinda confirmed with this thread is that on hard acceleration the axles bend to an angle where its...
Ok so this has been discussed many times however I want to have an engineering look at it. My Tesla S 2016 P90D pre lift had the shrudder thing, basically driveshafts were broken, fine. So what I have done is I replaced them both, also checked the center bearing for the right half shaft and its...
Good luck, yea with wool you can put it anywhere, can fill every single hole, one advice though, use face mask when doing it, it spreads lots of tiny chunks when you play with it so not too good to breathe it
Hey guys,
I thought I would share my mod with you. I was experiencing some windshield noise with speeds over 50mph. I did some research and experimented with putting tape over windshield holes around. It fixed it so I came up with solution that you might find interesting. It completely fixes...
I was thinking of leaving it as it is now, it will still be usable. I actually removed the perpendicular piece that connects both the sliding and rotating covers so that I can access all space more easily with the new screen attached.