Recent content by Zokie22

Thanks for the response

Hi all, After some confirmation of what I need to do (based in Aus). I've got a 2022 Model 3 RWD and a set of SSR GTV01's from my last car I was intending to put on. SSR wheels: 18 x 8.5 +40, 5x114.3. Tyres: intending to take then off the current stock wheel and put it on the SSRs (roughly...

Hi all, I've got a M3 RWD 2022 with about 6,000 km's (got in March) with the 18's. I have a set of wheels lying around from my previous car and thought I'd chuck it on to make it a tad different (most common white on black). It should fit judging from the specs alone, however am unsure about...

I used Pickles DIY Inspect, you have to download the app which makes u take about 10 pics and a video of the engine running. Their response is pretty quick, within a business day (latest for me was a couple hours). If you accept they'll send a tow truck over, at their cost, and you'll get the...

Thanks everyone for the advice and interest. An update, (different) electrician came round and had a quick look at it. I'll describe best as possible (to my the Thanks all for the feedback and response. Update today: an (different) electrician came round and had a look. From my limited...

I don't have a sub board inside the house that I'm aware of, haven't seen an external electrical box either

Apologies, it didn't attach in the previous post. I have a different sparky coming on Tues (for other stuff), have mentioned this to him so he'll take a look whilst here.

Thanks everyone Final comment - turn off all the other circuits on the board(s) and then run only the charger 32A circuit. If it runs without tripping the main breaker then you have proof that your mains is overloaded. - Will give that a go tonight when I get the car back from putting on PPF...

I'll contact the sparky (yes he was licensed) to come and take a look again. It could be a different breaker, there are 4 more but those weren't tripping (or labelled) so I only took a picture of the breaker that did trip. Thanks everyone for all the responses,

It's the orange switch. The black ones stay up. The numbers I can see are 63a and 30mA

Oops, the url doesn't update based on selection. It's the 32a 3pin selection highlighted below. OK gotchya, I'll give him a ring tomorrow and ask him to have a look. Thanks for the response

Thanks for the response. I've been charging via the 10amp for about an hour now so the charger itself doesn't seem to have an issue. With the 32amp tail, as soon as I turn the main on the circuit immediately. I just tried setting the charge to 5amp before disconnecting the 10amp tail. Then...

Hey all So picked up my Model3 RWD today in Alexandria! Drove it back home and installed the update. Since its sitting at 40% thought I'd just charge it to full tonight. My (budget) charging setup is a 32amp single phase switch and I've got a 32amp 3 pin tail (Gen2 Mobile Connector Adaptor...

Thanks both for the responses. I'll use this as an excuse to start driving more :).

Hi all, I'm getting my SR in a couple weeks so have been reading this helpful thread. My situation is 4 days a week we typically only drive 8km a day (4km round trip in morn and 4km in afternoon), one other weekday maybe 20km, weekends we'd drive maybe 70km. So I'd say about 130km (80 miles) a...