Separate names with a comma.
Sorry for the late reply. It has been a while since I've been on here. You are 100% correct. I just wedged the rubber tubing into the molding area...
You are probably correct on both points. I read up a bit on how people soundproofed their cars (all makes and models - not just Teslas). There...
Hi, The build date on this one is 07/19. This is the only Tesla I have ever driven, so I unfortunately don't have anything to compare it to...
The door panel is a bit harder to get back on and needed some heavy hip bumping to get some clips to snap in due to the extra material between the...
Next up, I covered the inner door shell (again with the technical terms). I was on a roll after finally finishing up the outer skin, so this next...
It's now time to start slapping on that sound proofing/barrier/deadening material! I went with Kilmat. I am not endorsed or anything. I read a few...
I didn't remove the large plastic piece in the center of the door completely, because that looked to be too much of a hassle. After taking all of...
Now that the door panel is off and moved out of the way, let's start removing things to give us access to the inside of the door frame and where...
Disconnect the 2 cables holding the door panel on. 1) Pressing in on the small tab, disconnect the wide plastic connector from the control box (I...
Now for the part that will make you cringe if you haven't done this before. I suggest placing a box or something below the door that the panel...
Next up, I will be removing 4 10mm screws from the door panel. 2 of these are located in plain view where the trim piece was just removed. 1 is...
OK. Let's get to work! Time to get that door panel off. 1) Begin prying on the edge of the long skinny trim piece shown below. You will feel and...
Here are the tools I used for this project: 1) Kilmat 80mil 36 square feet sound deadening material pack. *...
Here are the things that I have tried in the past before we get started on this project: 1) I filled the 'A Pillars' and front wheel wells with...
Disclaimer: I am not responsible for any issues that may occur if you try to do this yourself. This is only to show what I was able to do and how...
I would take a pretty good guess that this was done by a previous owner. Mine is a mid 2019 model, and Tesla didn't install them up to that point.
It was trickier than I expected. The video stated you have around 15 or so seconds, but it was less than that. The A Pillar is already a tight...
Hi, Of all of the things that I have done for the wind/road noise, the foam filling helped the most followed by adding extra insulating tubing...
Hey everyone! I have a 2019 MX Raven. Since purchasing it, I've obsessed over getting all of the road/wind noise and the cosmetic alignment issues...