Separate names with a comma.
Yes, this is consistent across lots of people. I don’t think it impacted the actual capabilities of the wall connector; just your ability to...
OP - Not sure that you got an answer to your question as the thread went a little off topic... I have an S, so the absolute values are higher in...
Factory
When I do this all I get is a nice picture of the HPWC and the part/serial numbers followed by an infinitely spinning little circle. Any ideas on...
Standard
I drove cross country RT and it felt perfect. I think the only thing to be cautious of is the suspension height when aligning as not too many...
I had my EV Tuning arms installed by Electrified Garage. These are the specs and results of where they put mine.
FWIW, my tech suggested that if your goal is to minimize tire wear while running in Low the majority of the time, have it aligned at Standard...
That is one interpretation, but in this context I think they are just warning people that some third-party apps keep the car awake, which drains...
This might help. Gen 2 NEMA Adapters
FYI, it does auto-stop; it just waits until it gets to 0.5 psi above what you set, e.g., 45.5.
Nominal full pack is also available from ABetterRoutePlanner if that’s all you want. Scan My Tesla gives you a ton of information, but requires...
Yes, you'll need to let the car know that you've changed sizes if you want energy calcs, etc. to be correct. If you forget, it will "detect" that...
I don’t know what a Geo setup is, but I’ve swapped wheels as described and only needed to change the Wheel Configuration in the menu, Obviously...
Need to travel on short notice and want to have this adapter with me just in case. Tesla only ships by ground which won't make it to NY in time....
My gut reaction is no, it is not normal, but to be honest I've only charged to 100% myself once. It stayed at 48A all the way to 99% and tapered...
To add some clarity to the above posts for future readers... It is the call to Tesla and the conversation which encourages them to push the...
A window "calibration" usually fixes this without a service call. Tesla window is open and how to reset it
Your issue is different. There are several threads running about this issue in various forums on TMC. Here is one to get you started. Tesla wall...
How do I change the change level after charging? Is this a TeslaFi capability?
Mine is similar but worse. After charging the car sleeps for only 10 minutes, then idles for 12 or 16 minutes, then repeats this sleep/idle cycle...
I can't say enough positive things about XPEL and my installer (Mohawk Collision). I had a full wrap done and I think it looks great! The film...
It’s supposed to come automatically, but if it doesn’t you can call them and get it pushed. For the record, it improved my charging situation as...
FYI, I tried mine again last night after getting the new firmware (1.3.0). On the plus side, it maintained 37-40A throughout the entire 4 hours of...
Glad yours is working well. I tried mine again last night after getting the new firmware (1.3.0). On the plus side, it maintained 37-40A...
Firmware 1.3.0 now available for Gen 3 HPWC. Let's hope this addresses the "phantom" overheating.
Tesla has pushed 1.3.0 firmware to my Gen 3 HPWC. Here's hoping that it addresses the "phantom" overheating. Obviously it won't do anything for...
Yep. 1.3.0 was released today. Looking forward to charging tonight at 48A to see what happens!
To close the loop... I contacted Chemical Guys, and while they didn’t give me the recipe they did confirm it doesn’t contain petroleum distillates...
Agree this is not a good idea, but you can always tap Standard once you're on the highway and it will move there for that trip anyway.
If your settings for Auto put the car in Low for highway driving, then this kind of wear is pretty normal, if not pretty good considering you got...
Hey XPEL! Can I use Chemical Guys Synthetic Quick Detailer on my Ultimate Plus film? Their website isn’t very informative as to the ingredients...
Curious on specific signals you are using to calculate this. I'm using ScanMyTesla and at 45C/70%SOC it is showing "front drive power max" of 387...
Seems like it mostly just the 36.3 capabilities released in more countries. 2020.36.10 Official Tesla Release Notes - Tesla Software Updates
I understand your point, but I also want to make sure they actually have it fixed before I get another one. Since you just got yours on...
There is a calibration process involved, so an undocumented quantity of driving is required before it will "just start working".
Mine works fine on 2020.36 and later. Other threads have mentioned doing a "window calibration", i.e., roll the windows all the way down and then...
Agree. I haven't heard anything from them since they took my initial report on 8/25.
Car only detects black on white SPEED LIMIT signs, at least for now...
TeslaFi seems to be back in business even though the announcement at top of page suggests it is only temporary. Who knows how long it will last.
You mean like Scan My Tesla? The app and OBD device and will give you all of the data and then some, but you have to manage it. That's the hard...
The Brits seem to be very active. I guess it was in the middle of the afternoon for them when this went down (pun intended). Teslafi issues?...
Several other threads running on this. The outage also extends to Google Cloud and Microsoft Azure, in addition to Amazon Web Services. Seems...
It would be interesting to know if it updates to .8.58 which is when the trouble began for me. Please keep an eye on it and update as appropriate....
When you connect to the wall connector via wifi on your phone, it has a summary page which shows current configuration, including firmware.
Just had mine installed at Electrified Garage. They look great and the alignment came in right on the numbers. Thanks Chad!
No reset for me, but it did take a while for the calibration to complete before it started recognizing speed limit signs.
Curious whether or not you can say it charges any faster this way, or if the “fast-charging” ports are basically same as the data port?
Upon further testing, I have to amend this statement. It did recognize TOWN SPEED LIMIT signs and showed them as just SPEED LIMIT signs in the...
Obviously I don’t know about roads in MA, but this wouldn’t be an unmarked road if it had a speed limit sign. I’m pretty sure my town law...