1:1 Dual Motor logo?

[dusty]

I am bout to take delivery of my MYP and have the black emblems to go on it. I was looking for a 1:1 printable Dual Motor logo that I could use to properly align my replacement Dual Motor logo. I am very OCD and know if I try to do it by eye then I will not get it straight out aligned correctly and it will always bother me. Does anyone know of where I can find a 1:1 printable version of the logo I can use as an alignment tool? Thanks in advance.

PS: I know some versions come with a template. Unfortunately the one I purchased did not come with said template.

 

[Black306]

Auto manufacturers use a jig to align badges.

I'd suggest to make a jig or use blue tape to mark the existing badge location before removing the old one.

 

[dusty]

Auto manufacturers use a jig to align badges.

I'd suggest to make a jig or use blue tape to mark the existing badge location before removing the old one.

I do intend to mark the location of the old one with blue tape. However, I would still like a 1:1 image so I can ensure the alignment is correct

 

[Kairide]

Use masking tape to outline where the new logo goes and a laser level to make sure it’s straight.
If you’re really worried, just plastidip the emblems and you won’t have to worry about removing and replacing them.

 

[TomServo]

I have a MSM PMY on order and just bought a matte RED performance DUAL MOTOR emblem. My PPF a guy will swap them for me. But I was going to DIY by placing a piece of painters tape under the LINE to mark the OEM location.

 

[fr4c]

When I replaced mine with black badges, I just measured the OEM location using the edge of the trunk lid and also the horizontal crease/body line. Probably 99% accurate compared to the stock location.