Tesla Motors Club
Over the weekend I began the removal of the Kenwood KVT-614 installed by Al & Eds in my 1.5 for my car's prior owner. I'm upgrading to a Pioneer AVHX7700BT. After I pulled the Kenwood, I discovered that the original harness plug had been cut during the Kenwood upgrade. I'd really like to go back to the original Lotus/VW style harness connector and then connect the Pioneer harness to a VW01B/VWH-1004 plug to connect to the car. This way the harness itself would be "stock" (or at least reconditioned to a stock-ish state). Does anyone have a 1.5 harness connector laying around that might have been clipped for an upgrade?
Also, the original pinout or wiring schematic would be very helpful. Hopefully I can mostly reverse engineer it from the Kenwood wiring schematic. There was an dark orange/red wire with a black stripe that was not connected and there was a light green wire with some yellow tape near that end that was also not connected. Those two are a mystery.
Thanks!
Also, the original pinout or wiring schematic would be very helpful. Hopefully I can mostly reverse engineer it from the Kenwood wiring schematic. There was an dark orange/red wire with a black stripe that was not connected and there was a light green wire with some yellow tape near that end that was also not connected. Those two are a mystery.
Thanks!