FS: Used H&R Spacers (14mm)

[KyleM3]

Selling my used pair of H&R TRAK+ spacers (14mm). These were installed for 10K miles and required zero modification on the front of my car. I have the 2020 satin sports wheels and an M3P.

Tons of life left, zero issues. Simply went wider up front and in the rear now.

Selling for $100 OBO. Shipping from 19130.

 

[JustAdam]

Is this for 2 or 4?

 

[KyleM3]

Is this for 2 or 4?

It is for 2 14mm.

 

[reds2k1]

Do these include the extended shank lugs?

 

[KyleM3]

Do these include the extended shank lugs?

No, they were not necessary (I didn’t order a kit with the extended lugs), nor recommended by H&R over the phone. The rears had the extended lugs built in. They come as is, direct plug and play (for a 2020 P, at least).

 

[marmaladedad]

No, they were not necessary (I didn’t order a kit with the extended lugs), nor recommended by H&R over the phone. The rears had the extended lugs built in. They come as is, direct plug and play (for a 2020 P, at least).

Was it necessary to remove the small fixing bolt on the rotor in order to install these spacers?

 

[KyleM3]

Was it necessary to remove the small fixing bolt on the rotor in order to install these spacers?

I didn’t install them, but I’m close with the shop that does and remember asking them if the rotor bolt needed to come off. I don’t believe it did, I think that was the rears? Either way, it wasn’t an issue.

 

[reds2k1]

No, they were not necessary (I didn’t order a kit with the extended lugs), nor recommended by H&R over the phone. The rears had the extended lugs built in. They come as is, direct plug and play (for a 2020 P, at least).

The extended lug nuts as shown in the pic is what I'm referring to. They allow you to have the proper engagement to the bolts.

 

[KyleM3]

The extended lug nuts as shown in the pic is what I'm referring to. They allow you to have the proper engagement to the bolts.

View attachment 894691

Yes, and I’m stating the extended lugs (switched lug and bolt in my response accidentally) are not required for the 14MM in the front. There is zero issue getting the thread necessary.