[Goof!] Squished 2nd row headrest into rear of drivers seat

[DevonG]

Looking for repair ideas/validation. Back story:
Was detailing the vehicle, at one point my profile saved the seat position which was set all the way back. I later moved the seat forward, lowered down the rear seat for cleaning, and then when I opened up the driver door later after leaving the vehicle, the front seat went all the way back and squished the headrest of the 2nd row that was still down. Now I have creases in the back of the seat and in the headrest.

I'm itching to use a heat gun to get these wrinkles out. Is that a safe idea?

Thanks!

Side note: I wish there was a "cleaning" or "guest" profile mode for the seats. I don't want to always save seat position if I temporarily need to adjust it.

 

[Pianewman]

I would leave it alone for now. Your ambient temps might be sufficient, heating the material enough that the creases will come out.