GW2 "Panel Maximum Current" setting

[BGbreeder]

Today I saw what happens when you exceed this limit. I noticed that my solar production had gone to zero and when I when to look at the alerts it came back with max panel current error. I happen to be running a lot of loads with both AC units running, so I did exceed 100A for a bit. I have 200A service, but I assume because PW+Solar can send up to 60A back into the panel they set this limit as the max you can pull from the grid before shutting down the solar.

Oops! What does your Gateway say its current settings are? What is your layout, e.g. similar to what @GWord posted above?

All the best,

BG

 

[dailo]

The max panel current is set to 100A. I have a backup switch and there is an 80A breaker on my main panel that feeds the sub panel for my PW+ and PW.

 

[GWord]

Following up on an old thread here. I submitted a service request to have the 100A setting reviewed and changed. It was indeed limiting my production and powerwall output during peak current draw. Tesla remotely set it to 200A and all is well.