I just checked my new MY (delivered a week ago), and it does not save tilted mirror settings. The left mirror goes WAY too far down when pulling a trailer. I have to back my boat trailer up a 300' narrow driveway and through a garage door that only has about 5-6" of clearance on each side. The right side convex mirror is useless since the trailer, etc. is so small in it. The side cameras are also useless (wide angle), and of course you can't see anything through the rear window. The only thing usable is the driver's side mirror since it is not convex or concave so I can see the left side of the trailer and the side of the garage door opening. However, I had to slink down in my seat with my chin almost on the door trim to see the left side of the trailer and confirm it was not going to hit the side. After reading this thread, I went into mirror settings and did find that there is an auto-tilt on/off button. I was hoping I could turn the right side one on (because it is convex) while leaving the left side off, but no such luck. But I can turn both off, so going forward, I will turn auto-tilt off when I've hitched up the trailer, and turn it on the rest of the time. I'd love for it to turn off auto tilting when it senses I've got a trailer hitched up (it already automatically knows when there's a trailer there due to me plugging in the wiring harness to the car). And I'd love to see the tilting amount saveable as well as being able to enable and disable auto tilting per mirror (rather than both on or off).