I had a similar issue when I was first testing my ChaDEMO adapter many moons ago. It took some forcing to get the ChaDEMO plug into the adapter, and it took me a while to realize that it was still out by about 1/8"; once I did that, it clicked in and connected; but then charge kept failing. That was because I'd backed in a bit too far, the adapter was pulling to about 7 o'clock angle. I propped it up on the bollard protecting the charging unit so there was no strain and it worked fine. Others have said it worked for them, so I assume having the Tesla end charger plug hang at an angle instead of straight down made the plug pins not contact right in the 3's chargeport. Apparently the car can detect bad contacts. IIRC, I only got about 37kW max out of it; other commenters said that 50 was about the max ChaDEMO is designed for. And when it was done, it was difficult getting the adapter off the ChaDEMO charger plug... the opposite problem. I only used it that one time. Perhaps you're right, with age and use it will become easier...
50w is max yes but the ceiling is amps, it's rated for 125a. If your battery is at a low SOC your charge voltage is also. Volts x Amps= Watts. Your charge rate will rise as voltage rises. I've occasionally seen 50kw from chademo but not very often unless i'm charging to a high SOC.
Yes, that was me -- from what I could tell externally, it's ready to go, and from what I could see on the screen, the installer needs to complete the setup. Just for kicks and giggles, I ran through the setup as far as I could go, until I was asked for enter the installer code or use the RFID key.
I recall reading about a problem many years ago - these small stand-alone ATM's. The manuals were apparently online. You can't get at the cash without an actual key, but someone figured out they hadn't changed the factory default setup code; so they went into the programming and told it that the 20's tray was actually 5's. Withdraw a large amount, get extra 400%. Change back. Similar case - someone programmed a self-serve pump to charge almost nothing per gallon. Apparently people were filling up all weekend on credit card and nobody mentioned anything to the attendant.
South Sioux City, NE is now open. We used it Sunday. Its great to have redundancy in this remote but key location. I've spent too many hours sipping off of the J-1772s there just to be sure we'd make it to Worthington.
Tried the Chargepoint yesterday. Worked great and so much better GUI than Greenlots. However, I had a little issue getting the adapter uncoupled from the plug once I was done. Eventually got it but there were a few tense moments where I wondered if I'd be able to. Just a heads up.
I had this problem here and previously. I believe it is best to disconnect the CHAdeMO connector from the Tesla Adapter, then disconnect the Tesla Adapter from your car.
Small update: Tesla very recently updated their Find Us map. Looks like Sioux City is now slated for Q2 2021. Fingers crossed.
For the newbie to the Sioux City supercharger conversation, here’s the current situation: Construction on the Tesla SC has not been started. Tesla is still saying “Second Qtr 2021”, but who knows. For now, the best you can do is Chademo. But luckily there are two (or so I’ve been told. I haven’t actually seen either one, but I trust those who have posted here before me): HiVee, 2501 Cornhusker Dr, S. Sioux City NE Kum and Go, 1005 Gordon Dr, Sioux City IA On the supercharge.info map, you can add a Custom Marker (right click on the map) to make them easier to find later. (only you see your Custom Markers) Happy EVing!
More details for the two sites are on PlugShare which document successful DCFC charges at both sites: PlugShare - Find Electric Vehicle Charging Locations Near You PlugShare - Find Electric Vehicle Charging Locations Near You Note that the Kum and Go (Greenlots) site has become more expensive, so the HyVee (ChargePoint) is a cheaper option.