You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
Got the 305/30/19 Falken RT660's installed on the 10.5x19 ET25 MW03's! I believe they call this - snug.
View attachment 800853
@MasterC17 more camber?
Already done after I took the previous knuckle photo. Shaving a few mm off the knuckles is easy!
I heard you were being persuaded to do so . And here I was concerned about fitting a 275/35/19 660 on a 19x10 +35 lol.
What rims are you running? I have the same tires on 9.5 and don't like the result in auto-x.I heard you were being persuaded to do so . And here I was concerned about fitting a 275/35/19 660 on a 19x10 +35 lol.
What don't you like about the FT660's? What's your suspension and alignment?I have the same tires on 9.5 and don't like the result in auto-x.
19x10 et35 MRR M600…What rims are you running? I have the same tires on 9.5 and don't like the result in auto-x.
I don't see how that can move up.I spoke too soon. I used a Hunter laser alignment machine in a rush a few weeks back to get out to an AutoX event. As per usual, those machines are proving to be highly inaccurate. Manual measurements show my rear camber was only 2.2 degrees, not the 2.9 the lasers had shown.
So, I set them to the max-without-going-too-far of 3.2 and lo and behold - I think these puppies actually fit!
View attachment 801595
I don't see how that can move up.
That's fully compressed (spring removed, sway bar off).
ET35, these fit with the thinner performance rotor hats without spacers or rubbing?19x10 et35 MRR M600…
What don’t you like about them? In 2 events so far in less than ideal conditions I’ve been 3rd in raw and FTD. Seem to be doing just fine
View attachment 801559
With 265 RE’s yes. With 265 Falkens I needed a 5mm spacer. Next year I’m going to 275 and will probably need studs and an 8mmET35, these fit with the thinner performance rotor hats without spacers or rubbing?
The lengths you go for the science are impressive.Basically if it moves up any further something is terribly wrong
I don't like the 275s on a 9.5 rim. I think they are a bit less stable and wearing more in the shoulder. I think the 275 likely just needs wider rim then I am using, otherwise the tires seem like they should be great.19x10 et35 MRR M600…
What don’t you like about them? In 2 events so far in less than ideal conditions I’ve been 3rd in raw and FTD. Seem to be doing just fine
View attachment 801559
What camber and toe are you running?I think they are a bit less stable and wearing more in the shoulder.
So, it sounds like if one doesn't want to run 3 degrees or more of rear camber, these ETs are still a good target to shoot for?This is why I think somewhere between an ET30 and ET35 would be the perfect square setup for our cars.