Hey, I had Suntek Cir (suntek Ceramic tint) installed and I'm not thrilled over the job. Specifically, the rear window/hatch. The installer claims he shrank the film but it didn't shrink enough because the film is "stiffer" and had to put relief cuts in and over lap the lines a bit. I'm actually shocked and pretty mad because he could have easily cut a defroster line!
I confirmed it's one piece but the relief/overlap is about 12", two per side.
He botched this tint pretty bad in a different area so I'm having him redo it so...
Question is, is this normal? Does your Ceramic tint on the hatch have these reliefs?
If it's not, I probably will tell him to just remove the tint and I'll go elsewhere. Actually thinking of just getting a precut piece and doing it myself.
I confirmed it's one piece but the relief/overlap is about 12", two per side.
He botched this tint pretty bad in a different area so I'm having him redo it so...
Question is, is this normal? Does your Ceramic tint on the hatch have these reliefs?
If it's not, I probably will tell him to just remove the tint and I'll go elsewhere. Actually thinking of just getting a precut piece and doing it myself.