Greetings all,
I haven’t seen too many installs on decorative stone. Turned out great! Car will be parked outside so indoor mounting would not be ideal.
- Grinder with diamond wheel was used to carefully cut out the stone.
- PVC trim board was used to bump out the Charger enough to clear the stonework.
- 3/4 liquid-tight conduit into the garage, then 3/4 greenfield to panel.
Enjoy!
Parts Used:
50A breaker
12 feet 6 awg wire (red, black)
12 feet 8 awg wire (green)
10 feet 3/4 greenfield (FMC)
1 foot 3/4 liquid-tight (NMC)
3 feet PVC 1x6 trim board
1 straight FMC 3/4 fitting
1 90° FMC 3/4 fitting
6 3/4 FMC wall clamps
2 straight liquid-tight NMC 3/4 fittings
1 molded lamp box 3/4 threaded knockouts
3/8 x 4” Tapcon screws
1/4 x 2” Tapcon screws
1 Tesla Wall Charger
I haven’t seen too many installs on decorative stone. Turned out great! Car will be parked outside so indoor mounting would not be ideal.
- Grinder with diamond wheel was used to carefully cut out the stone.
- PVC trim board was used to bump out the Charger enough to clear the stonework.
- 3/4 liquid-tight conduit into the garage, then 3/4 greenfield to panel.
Enjoy!
Parts Used:
50A breaker
12 feet 6 awg wire (red, black)
12 feet 8 awg wire (green)
10 feet 3/4 greenfield (FMC)
1 foot 3/4 liquid-tight (NMC)
3 feet PVC 1x6 trim board
1 straight FMC 3/4 fitting
1 90° FMC 3/4 fitting
6 3/4 FMC wall clamps
2 straight liquid-tight NMC 3/4 fittings
1 molded lamp box 3/4 threaded knockouts
3/8 x 4” Tapcon screws
1/4 x 2” Tapcon screws
1 Tesla Wall Charger