Trunk trim warped?

[HeyEph]

Does anyone else have this problem? The upper trim panel where it meets the hatch gasket is warped. Tried to see if there was a clip that came undone, but can't find any.

 

[Jjrss]

The weather trim should be retaining that.

 

[SvenG]

Yes, there are no clips in that area. Just had that part removed yesterday and it is being held by the weather seal itself.

 

[HeyEph]

The weather trim should be retaining that.

It doesn't. Pops right out.

 

[SvenG]

Is there are chance to push the white insulation back a little? It might cause the extra load on that trim.

 

[HeyEph]

I truly think mine is warped, as the weather trim doesn't retain it.

 

[HeyEph]

Is there are chance to push the white insulation back a little? It might cause the extra load on that trim.

I'll try that. Thanks.

 

[Jjrss]

It doesn't. Pops right out.

There should be some retaining clips, maybe 3 or 4, along the seam between the roof liner and lower trunk section.

Ensure they are engaged, and the slip the weather strip over the entire edgeline from top to bottom.

 

[HeyEph]

There should be some retaining clips, maybe 3 or 4, along the seam between the roof liner and lower trunk section.

Ensure they are engaged, and the slip the weather strip over the entire edgeline from top to bottom.

I don't feel any retaining clips. Also tried moving the insulation, but it doesn't seem to be blocking it in any way. I guess I'll make an appointment.