Tesla Motors Club

I just finished installing the 80 amp wall charger in my carport. It’s on a 50 A circuit with a NEMA 14-50 outlet that I have been using with my mobile charger. I used the top power feed plate with its own interconnect wires to the charger.

I noticed that the interconnect wires seem to swivel side-to-side in the plate junction block even though their anchor screws seemed to be very tight. Is that normal?

The charger seems to be working, but the charge rate is a bit low. It is chilly here, so perhaps the battery being cold isn’t charging as fast.

Thanks!