Hi everyone.
Long story short:
I’ve got an Hansshow subwoofer with a broken harness. The subwoofer is working fine but the harness has some of the rear speakers was reversed, some wires were broken and the DSP box wasn’t working correctly. I pulled it out and was much happier without the Version B upgrade The car is a 2020 SR+ with factory speakers and rear speakers.
Last weeke I’ve installed a regular DIY Hansshow harness and everything is working. All the speakers are activated but I still need a little bit more bass.
Now I need a place to tap into to get a signal for the sub. This would be a Frankstein Hansshow setup.
Is this possible with the DIY harness and a homemade harness to the Hansshow subwoofer?
Long story short:
I’ve got an Hansshow subwoofer with a broken harness. The subwoofer is working fine but the harness has some of the rear speakers was reversed, some wires were broken and the DSP box wasn’t working correctly. I pulled it out and was much happier without the Version B upgrade The car is a 2020 SR+ with factory speakers and rear speakers.
Last weeke I’ve installed a regular DIY Hansshow harness and everything is working. All the speakers are activated but I still need a little bit more bass.
Now I need a place to tap into to get a signal for the sub. This would be a Frankstein Hansshow setup.
Is this possible with the DIY harness and a homemade harness to the Hansshow subwoofer?