Recent content by bigjoefatz

Just to tie this together, it was a compressor failure + PTC Heater failure. I am getting it fixed currently (I've been away on business). Just a quick question - the mechanic has given me the option to source my own compressor. The one on my car is 1042442-00-I but I found one that is...

What was the issue

Do you remember how much the motor replacement cost?

To disconnect the 12V without removing the frunk, presumably the right steps are to: 1. Power off the car through the touchscreen 2. Open Frunk and disconnect Fireman's loop 3. Disconnect 12V positive terminal at the fuse box 4. Wait a minute 5. Reconnect Sounds right?

If you go into service mode, while the error is or was recently active, you can see what the failure means.

And the error cleared after a hard reset.

Also just to add a little more context: although I am getting the THC 0016 error (compressor failure) when the error is not present the AC runs cold. Makes no sense. Either the compressor is burnt out or it isn't.

Error came back on while driving after 2 days (and after multiple supercharging sessions and multiple cycles of turning on the AC). If the compressor was faulty, wouldn't the error just stay on?

how long does the thermal test take?

I received a software update overnight and the error cleared. No idea if it's temporary or a real fix.

Do you think it could be the 6 year dessicant bag replacement?

2017 Model X P100D here - I had my pyro fuse replaced today under warranty. About 45 mins later, i got the "AC reduced/Supecharging may be limited" message (THC_w0016). It was only between 60F-70F degrees where I am. And the error came on without supercharging. Not sure if they are related to...

You aren't wrong but it's cheaper at Tesla lol

Just checking here if anyone knows if this is a 4 piston brembo, single piston brembo, or a single piston mando

Hello, I have a 2017 Model X P100D. Just curious if the following Brembo kit for my rear fits: KT00410 – Brembo Store USA The rotors in the kit have the same diameter and thickness. However the break pad thickness in the kit (14.7) is much thicker than the spec in my on-screen manual (9mm). Is...