Recent content by Gil Shanley

i was having the same problem, milky with no improvement after several attempts with various cleaners. Called my local auto dealer and he suggested its was "water stain" and suggested Bio-Clean, a water stain remover. Bingo. It worked!

This is a powerful forum. After I sent a message, see above, that my charge port was randomly opening, it quit. Thanks forum!

I received it as 2020.12.6 I am an early accesser! Or once was.

During this time, I have been leaving my MX plugged in. Recently after a trip to the store, I drove into the garage and got out of the car. As I was closing the driver's door I heard the charging port door open. This has happened a few times. Toughts on why this is happening?

One of the most exciting things about owning a Tesla is the over the air improvements. Since I bought my MX last June, there have been significant improvements. Including smart summon, voice commands, increased range, recognition of stop signs and stop lights, and others. And, as they say, the...

No they did not.

It is both. I asked a TeslaRanger whether I could upgrade the hardware and he is trying to find out if this can be done.

My 2019MX quit auto presenting (opening!) the door as I walked up a few months after I acquired it in June. I called tech support and they sent a ranger who replaced what looked like a small mother board in the wall under the glove box. Took around 2 hours. He said they had had trouble with...

You can also respond to the vehicle's request by moving either of the wheels on the steering wheel.

Works intermittently. Some commands it responds "not available yet" works sometimes on "set temperature". Seem to work better if I vary my voice pitch. Dome light works both on and off. Glove compartment open does not recognize. Sometimes no response at all. Very Beta!!

Use the roller buttons on the steering wheel. A little movement of either of them will suffice to apprise the car of your presence.

I will be on a four day trip, flying. Will leave car in my garage. I have a Tesla Wall Charger. Question is, should I leave the charger plugged in while gone or not? Thanks for your responses.

Not so. My X registers cones without being in NAP. Also registers barrels as cones!

Before Raven, MX will not allow hold mode and does not have new chip

Actually, I mean TeslCam file. and I am working with SentryView APP. the Regular Sentry mode works fine.