Recent content by ParaAdBellum

I did not get any email confirmation either. Curious to hear if you got an email after 2nd submission of the form

Same here. Submitted offline365 form last Friday. Still enrolled

I disconnect HV and 12v battery.

None that I can notice. It just goes back to normal.

Another update (2024.3.25) and another instance of trunk failing to open. Update was performed with trunk 2 wire cable disconnected. Power cycle fixes the problem. Very annoying

I should also note that at first loss of power steering was intermittent. Only after I took the connector out and cleaned it, it failed completely.

2020 SR+ They don’t service broken parts, they just replace them. It so happens that the corroded pin is attached to $2300 or so part. Very sad

I had similar issue. Problem turned out that electrical connector to steering rack power supply has corroded. It’s unclear how water got into it, but the whole pin disintegrated. Probably took some time to fully corrode. Check out the top pin in the pic. Service said the whole steering rack and...

Would be good if someone could confirm my observations are reproducible

Hard reset by disconnecting hv and 12 volt fixed it

Reinstall did not fix it

I’m in the same boat here. Today attempted update from 2024.3.10 to 2024.3.15 with trunk 2 pin cable disconnected. After the update, trunk no longer opens at all. Not physically or via computer display. Trying reinstall via service menu with trunk connected to see if that fixes it.

Turns out this is caused by trunk retrofit and recent software bug discussed here Thread

As mentioned earlier replacing 12v did not help. Factory reset did not help either. I’ve acquired 12v monitor and I can precisely tell how many sleep wake cycles occur overnight. I now worry about high voltage contractors wearing out prematurely because of this cycling

Ugh, spoke too soon. Pattern of sleep/wake cycle reappeared overnight. Must be something else.