Recent content by Rheckbert3

There were 5 wires from the EU 13 pin connector to the conversion module with an additional jumper wire connected on the connector. from the conversion module to the 4 way flat connector there is 4 wires. From the EU 13 Pins connecter to the conversion module there is: Pin 1 - Yellow - Left...

I would just use the Tekonsha 118869 unit as it directly plugs in line with the factory tail light harnesses. It cant "lose its memory" of the programmed sensor positions as everything directly hardwired with connectors...

Sorry, yes you are correct in thinking that the adapter I pictured is backwards from what I was trying to achieve. I just included that picture because the seller showcased the internals of the adapter in this configuration. I was trying to convert Euro 13 pin to US 4 pin. I attached a picture...

DIY Trailer 13 pin to 4 pin information: Originally I had the idea to get the 13 pin connector from the trailer ECU, chop off the 9 unused wires and solder in the 4 wires from a US flat 4 trailer wiring pigtail…..but it’s not so simple. Let’s look at the wiring for a 4 pin connector and a euro...

I agree it’s a shame that there isn’t a US spec trailer module for the M3. There is of course a US trailer module for the MY but the connector to the car side vehicle wiring harness is different. The Tesla M3 is not rated to tow within the US but is of course often used to tow in Europe. I...

I just recently finished installing an EcoHitch Trailer Hitch on my Tesla Model 3. I wanted to create a comprehensive write up about which hitch I chose, the installation of the hitch and wiring as well as the options I had for installing the trailer light wiring. I have a November 2021 Tesla...

This 3 wire connector is connector X041 SUMITOMO 6189-0165. I believe the opposite mating connector is 6188-0129. You can get this very cheap on Alibaba for a buck or two. I purchased both sides of the connector from Alibaba and am waiting for it to come in. I am planning on using this...

Link posted on the door

Once you have the hardware for the Homelink module installed you must activate the Homelink module in the software of the car. Tesla has finally enabled you to do this part DIY through the service mode. Do this only after installing the module. 1. Go to the car menu -> software -> press and...

Homelink installation on 2021 Model 3 SR+ without removing bumper facia. This step by step guide shows how where and how to mount the Homelink module under the frunk. Bought Tesla Homelink kit part 1098355-00-B on eBay for $180. This includes bracket, bolt, and Homelink module 1114984-00-B. If...

This isn't true

If I install the HL hardware and activate it in service mode on my 2021 Model 3 will I still be able to activate MyQ Connected Garage at a later date?

Tavern In The Square coming along!

The new ones just installed in Burlington, MA don't have CCS plugs. https://teslamotorsclub.com/tmc/posts/6625060/