Recent content by Bruce G

I had this same issue after using my UMC for 4 years. I found that using contact cleaner spray on the outlet and blades of the charger solved my problem.

I had the same "charge port not latched" message with reduced charging. I went into my trunk, wiggled the latch release cord a few times and managed to free the latch and extinguish the fault. I'll hit it with some lube tomorrow, fingers crossed it's resolved.

I just finished a 5 minute test charge without preconditioning (-7 degrees) and saw about 220 km/hr. All the pedestals were lit up.

I stopped in yesterday to see if the chargers were active and was encouraged to see them lit up. I was able to open my charging door with the cord end but alas no juice was flowing. I left it plugged in for about 10 minutes while I went inside, no change.

Looks like this site's complete, ready for Tesla to do their thing.

Po Didn't see the previous post, looks like they took the weekend off.

I stopped by Sunday night to check on the progress, it looks like they're nearly done.

It looks like construction has begun in earnest.

I stopped in at the Shell in Prawda again this afternoon, the contractors are gone and the fence is down. It looks like there will be 6 stalls.

I was driving by this afternoon and snapped this shot. Contractors are making good progress.