Recent content by chmorley

It’s a Model Y. I did buy the right struts from Hansshow. The struts are installed correctly. I’m with you that there’s something pushing up from beneath. Basically, the hood is just a little low before the tub and hood (2 pieces on the Y) are installed, just a little high after they’re...

The lighting is terrible, so I'm not sure you can see it. With the frunk in, the hood bulges just a little on the driver's side near the wheel. With the frunk removed, it over-closes on the driver's side by a couple of millimeters.

Thanks. I messed around with it, but it didn't fix the problem. I was able to adjust the latch and improve the problem, but it's not 100% fixed. Still about 20% of the problem left--maybe 3mm off on the driver's side.

Thanks. They looks good. Both are present and undamaged.

Putting everything back together. Just one wire I can't account for. Where does this attach? I'm having one more issue. The hood is over-closing on the driver's side. I have moved the latch up, down, left, right, left up, right down, vice-versa--every way I can think of, but it's still going...

I took apart the latch, thinking it was the issue. I found the cable had gotten wrapped around the outside somehow. I straightened it out, re-installed, and it worked fine.

Figured it out. Had to fix an issue with the latch. It's all working now. Thanks!

Yes, it looks like that to me.

Thanks. The app actually shows it as closed, except for immediately after I either press the button or open it in the app. It then shows as closed again in a few seconds. I will try this shortly. I tried the Hansshow initialization, but it was unresponsive. It's supposed to start beeping after...

Struts look like they're connected properly. I don't know what you mean by "powered from a single ECU". Here's a more detailed video. More detail

This is it. Clicking

From the latching system. The struts aren't making any noise at all.

Got everything installed and connected, but it's not working correctly. When I press the button or open it with the app (with the hood wide open), it make 2 double clicks and then nothing. The app registers it as opening, but then says it's closed in about 5 seconds. Any thoughts?

Same, but those are 100% more accessible. Part of the issue I'm running into is finding a tool that's thin enough and long enough to pry that clip loose.

I'm having trouble detaching the struts at the top. When I watch the videos, they all seem to have a bit more room to dislodge at the top. When I use a long screwdriver, the barrel keeps me from getting the right angle on it. I bought a prying tool, but it's not sharp enough to get in there. I...