Recent content by DavidNauman

I put 12v to the compressor just to verify that it works, and it does. The suspension does not raise or lower but, in service mode you can see all of the suspension heights and the pressure in the superheated. I assume that the compressor won't run because of the version mismatch. Is there any...

I have a 2021 model s plaid. It has an active code gtw_w042 tas version mismatched and air ride compressor not working. I tried the software reinstall several times and the code remains active. The pressure and height sensors all appear to be working and reading correctly. I'm out of ideas. Any...

Update. They allowed the sale of the vcfront buy not the battery controller. I installed the new vcfront. It works! Thanks for the help.

So I called my local tesla service and they are unable to sell these to me due to an over the counter restriction. Where did you get yours at.

That's great. I mean I'm sorry that you had the same issue. Is there any way to confirm one or the other?

The post accident load shedding may be my issue. I tried to enter the service mode but I get the warning message that the vehicle alarm must be disabled to enter service mode. Is there any way I can do this without a key. The vehicle came without a key and I need the key card reader to power up...

There are no physical fuses that I'm aware of. It is a 21. Everything that I've read is saying that the fuses are virtual. The grounds are all good. I'm leaning towards a vcbatt issue. I just don't want to start throwing parts at it.

I purchased a plaid from a salvage auction. It was in an accident and the puro fuse has blown. Because it set on their lot so long the 16v battery was dead. After replacing both the pyro fuse and the lv battery the vehicle won't do anything except light the brake lights when the pedal is...