Recent content by Kcarver

I,ve had my system for 9 months and received the 18xB7 code on 7/18. However system functioned fine until 7/30. Put service request in on 8/1. Received email 8/2 asking for photos of error. Sent several emails and texts asking if received and what status was. I finally callEd on 8/4 and was...

I’m on SRP and turned the Grid Charging to “Yes” with reserved set greater than my PW SOC. I saw that PW did start charging from grid. So this feature is working in AZ.

I have iOS 4.3.2.742 and 21.35.3 on PW. I received ability to do 2 peaks on 11/9/21. lve set up the two peak for SRP and it’s working great. I think I saw the change when firmware went from 21.35 to 21.35.3.

Thanks for details @JayClark I’m in AZ also on SRP utility. I’m using just Peak and Off Peak setting for the 2 peak periods. ive been using Darwins Den Hubitat app for almost a year to get behavior I want. However it recently quit working due to Tesla server authentication and I can’t seem to...

I’ve read many are seeing in Cost Saving mode that all solar goes to grid during on peak and PW supply all house loads. I’ve tried this setting for a week and don’t see it. Solar supplies all house loads during peak and sends excess to grid. PW stay at 100% until solar can’t keep up with house...

I have 16.32KW and 3 PW. I’m on the SRP customer generation average demand plan. The 3 PWs have easily gotten me through the 2-8pm on peak with no demand charges even on the 115 deg days last week. This plan would not be economically feasible without the PW. The demand charges are too high...

I ran into same issue. I want to charge car at night from grid not PW. I’ve installed Darwin’s Hubitat scripts so after 8pm it sets to 100% reserve so PW stops discharging. Sets reserve back to 20% before 2pm. I set Cost Saving mode but don’t see difference in behavior from Self Powered the way...

I put my 3 PW in garage because I didn’t want them outside in direct sun. I received my first full month utility in March and it was $11.73. Only reason it wasn’t negative was due to the $32.44 monthly service fee SRP charges. I over produced enough to offset two thirds of fee. April may offset...

I’ve seen similar issue. I also see the Tesla app report 4-5kWh more in production at the end of the day than mySolarEdge app or my SRP Utility says I generated. yesterday Tesla app had 94.9kWh, SolarEdge had 90.09kWh and SRP had 88. Anyone seeing those large of differences?

How did you set 5 repeating actions? I have 7 spots to schedule actions and used 6 to cover the 2 on peak periods. I used the 7th to add same setting but 1o minutes earlier. I did not see an option to add more schedules.

Anyone else in AZ see storm watch activated today//tonight? Saw it this afternoon but PW were full. Now that I’m off peak 9pm see storm watch activated and charging PW at 10KW. It clear and showing windy tomorrow high of 82.

I’m using same setup. I moved the scheduled start time to 4:40am. Tesla app showed going off grid at 5:50am so not happening instantly. I’ll check throughout week to see if fixes issue.

74.9 KWh on Friday 2/26 with 16.32 KW 48 panels. My system is twice the size but produced 10 KWh less than yours if doubled your output. I have 35 panels facing west and 13 facing east. I’ve also noticed that SRP reports less than the Tesla app. For 2/26 SRP reports I only generated 69 KWh...

I received my first months bill after PTO. I’m on SRP average demand plan. There were several days during month where SRP shows using 0.1 to 0.7 KW during an on peak time. Most are occurring in the 5:00 to 5:30 AM. I’ve been starting Self Power mode at 4:50 but going to change to 4:45 to see if...

Thanks for providing info. I bought a set and they worked great. Ran system for 2 months while waiting for PTO that I just received yesterday. Lesson learned is SRP will allow you to put the solar and power wall meters behind a gate if they are within 10 feet of main meter. I failed first SRP...