Recent content by M4guy

A Any better photos? I would like one in black

Yeh my car is a 2015 P85D so has the smaller frunk already being AWD. The hood, ahem Bonnet is the main thing putting me off as I’d like to use the facelift item, they both use a single loop so I’d think a combination of relocating it and using the original loop you could use the facelift one

Great work, I’ve asked a few times but nobody has been able to answer.... Will a facelift bonnet fit if the ‘D’ loop on the bonnet is removed/replaced/relocated/changed back to the original one? As I recall another owner had to change the bonnet latch when installing the facelift hood

Sorry, I think you miss understood my question. I know the RWD models have a larger frunk and would need changing to a smaller one. My car is a P85D AWD so already has the smaller frunk the same as the facelift cars, so my question is will the facelift plastic trim panels that surround the...

Sorry, I think you miss understood my question. I know the RWD models have a smaller frunk and would need changing. My car is a P85D AWD so already has the smaller frunk like the facelift cars, so my question is will the facelift plastic trim panels that surround the frunk fit the P85D? As...

Anyone?

Looks lovely that buddy :)

Also, does anyone know if the bonnets ‘D’ latch can be cut off a pre-facelift bonnet and welded/fitted to a facelift bonnet?

Are the frunk plastics different and not interchangeable on the rwd only cars? If you have a ‘D’ awd model wouldn’t the new plastic trim fit?

Very strange, measure the length of your wheel studs (highly unlikely but they could be too long/extended ones

Correct :)

Q1. Rubbing against painted fender A1. No, plenty of clearance it’s not even close front and rear (and I’ve gone pretty low) Q2. Rubbing against wheel well when suspension is traveling A2. No, no issues plenty of clearance even when pretty low. Q3. Rubbering against suspension components A3...

I believe the arachnids are the same fitment as the staggered turbines but I’m sure someone will correct me if I’m wrong, I’ve gone for 20mm all round and I’d say it’s spot on and pretty much flush.

Sorry for the slow response, I used the hubcentric ‘design 3’ style. Yes 15mm doesn’t work because of the original studs length being too long and hitting the back of the wheel, obviously if you use the none ‘design 3’ Type ones they are the only studs being used you wouldn’t have that issue. I...

Same