Welcome to Tesla Motors Club
Discuss Tesla's Model S, Model 3, Model X, Model Y, Cybertruck, Roadster and More.
Register

ML Auto's latest activity

  • M
    ML Auto replied to the thread HVAC: Low Current Pump Failure.
    Drive it easy and you shouldn't have a problem. It takes a while to heat up the battery. There is not a lot of coolant volume outside of...
  • M
    There are a lot of variables for the pressure reading, but you should mention that there is a sight glass on the drier so that they fill...
  • M
    Based on your pressure reading with the A/C on, you are low on refrigerant. It should read around 13-15 bar.
  • M
    A couple a questions that need to be answered first: Does your A/C work? Does the A/C come on when charging? What is the battery temp...
  • M
    ML Auto replied to the thread Turning angle disabeling regen?.
    The regen turns off when some rear wheel slippage occurs. So if you are going around a sharp corner fast while braking, the inside wheel...
  • M
    ML Auto replied to the thread New Roadster owner.
    No.
  • M
    ML Auto replied to the thread New Roadster owner.
    That is the optional factory subwoofer located in the right rear wheel well, with a port that goes behind the drivers seat.
  • M
    ML Auto replied to the thread Dead Roaster - switchpack?.
    The multifunction relay is not the Tesla switchpack module. I have seen it called a switchpack in lotus applications, but it is just a...
  • M
    The EBC rotors rust a lot less than the stock ones. I only see slight rust if they get splashed directly with water. But the slots are...
  • M
    ML Auto replied to the thread HVAC not cooling!.
    Your pressure seems a little high. Are the fans working at full speed? They start on low and then kick on high around 15bar. If they are...
  • M
    The USR1070 work great with the USR Yellowstuff pads. You just need a 4mm spacer on the front calipers. The slightly larger front rotor...
  • M
    ML Auto replied to the thread HVAC not cooling!.
    Absolutely not! The dyes are mixed with oil and probably not compatible with an electric compressor. Adding extra oil always reduces...
  • M
    ML Auto replied to the thread HVAC not cooling!.
    Any shop that does A/C should be able to handle it. You don't need to worry about the service mode and the solenoids unless you are...
  • M
    ML Auto replied to the thread HVAC not cooling!.
    You are low on refrigerant. Your pressures should be around 15 BAR when the compressor is on at that ambient temp. 35' C is nothing to...
  • M
    ML Auto replied to the thread VMS Help.
    Here is a pic of the high voltage ESS disconnect (orange), located on the left rear of the ESS by the front of the left rear wheel. You...
    • SAM_4601.JPG

About Us

Formed in 2006, Tesla Motors Club (TMC) was the first independent online Tesla community. Today it remains the largest and most dynamic community of Tesla enthusiasts. Learn more.

Do you value your experience at TMC? Consider becoming a Supporting Member of Tesla Motors Club. As a thank you for your contribution, you'll get nearly no ads in the Community and Groups sections. Additional perks are available depending on the level of contribution. Please visit the Account Upgrades page for more details.


SUPPORT TMC
Top