Recent content by Moeb

Exactly. Dm me an email and I’ll send some photos over

Thanks. It’s the bumper cover the lower cover and bottom tray. All 3 parts have to be replaced for it to work, and even after that the bumper has to be modified by the tail lights for it to work. As far as the lights that go on the bumper I still have not decided what to do with that, therefor...

Just replaced the rear bumper on my m3p with the highland rear bumper not the best photos but I think it looks great

These are 20x11 with 285s all around haha Camber is around 3.2 front and about 2.7 rear. I can get more photos if you guys want to share it on your website

Ya you just need a shorter tire that’s all

15mm spacer would depend if you have a performance model or not, on the performance model the hat of the rotor is thinner therefor you might need an 18mm or a slip on to your 15mm if it’s bolted on. As far as camber goes my setup was on stock upper arm

This is with mpp rotor stock knuckle

There is 1mm of clearance with stock m3p rotors after shaving the knuckle. You cannot run this with stock rotors without shaving. However with mpp rotors it clears

That’s is correct, it will clear the knuckle with the mpp rotor other then that you need to shave the knuckle a little

Specs were posted already

Some photos of the 20x11

Some photos as promised

Will do!

Love these wheels

One more