Recent content by Steve Thurston

DRDUMONT, Which wires did you tap into on the dome light connector?? I couldn't find a wire in the front dome light connector that switched high/low with the dome lights sw. Just a + feed and pwm signals switching the lights on and off via the dome/hazard pcb. The rear dome lights connector...

Interested as well. For what I understand in the wiring diagram the pillar/under dash connector has an unwatched + and pwm signals to the overhead/hazard module, not sure tapping into pwm signals is possible. So I'm guessing it means running wires from the overhead module, I've been lazy lately...

I can't find the wire you mention in the console rear vent surround. The only wires I could see are the usb and console lid light switch wires. (M3 RWD 2022)

This sounds like a pretty good answer, I was prob going to end up tapping into cig wires anyway, but was going to see if the cig wires passed through a connector under the dash. I'll have to check it out. With a delay circuit, I could have the well lights stay on for 5 sec or so after the doors...

Just had a quick look at puddle light route, and there is only 6v across the light. Might have a look at the dome light route next week

For what I see in the print, the dome lights have a + feed with pwn signals, not a switch wire in the pillar connector. Gunna be easier to tap into puddle lights for footwell/door pockets. Not as fancy as dome light switching, but easier. And a sep push button sw could be added to turn the...

Where in Perth are you?

Not fully grasping the manual yet. Puddles front right are: Connector X053B for tapping into. Wiring pg 16. Map/dome lights are: Connector X981F Wiring pg25 Again, I'm still not grasping it fully yet, I need to be looking at the car connectors/Wiring to make more sense of it. When I...

Cheers. That's some pretty heavy reading lol Have to check it out more on my pc.

Will do, I got the subscription you mentioned, only had a quick look at it, but didn't see anything about wiring diagrams on plugs and wire colours, just instructions on how to remove stuff. I'll have to check it out more, the dome light harness must end up under the dash somewhere.

It uses dry contacts to sw on and off. The module I linked or similar would also be needed. I'm waiting on 2 of these to turn up as well (also req dry contact to activate)...

I'm going to grab one of these in a couple of days to see how they work https://www.jaycar.com.au/arduino-compatible-4-channel-12v-relay-module/p/XC4440?pos=1&queryId=4ff255e87ecba5f8df19b43e83adf24e&sort=relevance

I didn't read through the article because I fluked my frunk led strip issue, I had the frunk opening and closing in the app (even though it was closed), even got frunk error to contact tesla service, and emergency open button not working (close button if frunk open) My solution was to ground...

Other car door latch actuator?