Search results

Two pins for power ant two pins for the memory(position) function within the same connector. YELLOW - GRAY/ORANGE == power, BLACK/WHITE - GREEN/BROWN == sense, these colors are based on the GEN4 harness. If you have an ohm meter at hand, motors are 4 - 6Ohms, and sensors are in the 200KOhm...

It only seems daunting at first, once you start, it becomes more manageable. Start with your current passenger seat, remove the controls, harness and disconnect and label what all connectors from the bottom. Remove memory and heater modules also You need not to have the backrest dismantle at...

I wish I had one. Barely managed to extract and clean up this contour. There must be a one click option to create a vector format from this, but I'm utterly lost at image editing, as it turns out ...

Its also me (different PCs, different accounts, sry). I scaled these to 72mm width to fit, (70 might have been better) in my LaserPecker 2. Here you go:

He meant the blue circles in the wiring diagram in #125, I think. Anyhow, since I went in a different route by cutting just the white connector off of the new seat, it was BK/WH and GN/BL for me for the sensors. Managed to peak at the recliner motor connection under the bottom right side of the...

@yangotang The memory seat connection is unfortunately not detailed in the above guide. I did not connect it at all, and my backrest does not move, So, if yours does ( on a memory command) thats a good sign. Try setting the profile(s) from fresh and see if that works. Regarding the lumbar, WH /...