Search results

Apline did offered a 4 inch mid range speaker (DP-40) for BMW which can direct replace the original speaker of Model 3/y, not required bracket. U can found it on Apline Asia web site. https://www.alpine-asia.com/en/productDetail/156/DP-40C-B

Did u upgraded the sound system for Y?

Have u added the dsp finally? How did u collect the audio source?

speaker facing upward or downward or other direction better?

At the beginning I added a Amp with kickers 8” subwoofer replaced the original one on the original enclosure. This give u significant improvement . However, U will required an additional 12” subwoofer to allow the bass go deeper. U didn’t required a high power amplifier, around 300W-400W should...

Alpine S-W8D4 - u will required an external Amp. Without an external Amp, u can feel the bass improved 15-20% only. Furthermore, the entire space of the plastic enclosure will required to install sound deadening material. Alpine DP65C - the sound is clean and loud, but still lack of bass...

Not sure why the Apline package offered by Hepaking seems very popular. For local (HK) market, many peoples aware on the importance of speaker size and external amplifier, Hepaking is not their first choice.

I installed a hi-res mic at the driver seat with sound tool apps to fine tune the frequency spectrum with the EQ setting from modelY. This is the final frequency spectrum after my modification. I am sure there must have significant sound cancellation (similar issue happen on rear door mid range...

Mounting depth over 70mm may not able to install.

The actual output of the 16V system is around 15Vdc and I don’t think u required to step down for amplifier application.

At the beginning, I replaced the original subwoofer with a kickers 8” 200W plus amp. It did offer a significant improvement on bass but still not going deep enough…Hence, I added a genius audio 200W 12” with tailored made enclosure, both subwoofer powered by a 400W amp and the external enclosure...

I agreed with u. Still have many slim design 8” woofer and 4” mid range speaker in the market. I will not goto a smaller diameter too.

I am wondering the plastic enclosure may create noise when u install with a high power 10” subwoofer. Recently I had installed a 200W 8” subwoofer to the 8” original sub enclosure and a 200W 12” subwoofer to an external sub enclosure. Both were powered by a 400W micro amp. The 12” subwoofer...

U didn’t required to setup the soft start circuit if your entire sound system didn’t consumed more than 600W. From my experience, below 900W should be fine.

U can purchased a set of cables for collect the speaker signals from MCU and rear Amp without cut the original cable from Taobao.

Rated power of Scanspeak 10F/4424G00 just 15W. I am wondering not loud enough when fan speed set at 10….

Take away the rubber at the bottom and u can have a speaker with mounting depth around 49mm installed with adaptor.

If u added a Amplifier for the isu200, there will be a significant improvement on bass. If u look for a loud and clean speaker at similar price level, I would go for Audison AP8, not as good as issue for bass but it is clean and loud compare with isu200. For upgrade from isu200, I guess BLAM 8”...