Search results

Dear Koots, You've probably seen my posts above in this thread, but I'm still having very good luck with a small 12V in the trunk, and no need to fish wiring or search out damaged insulation: "I am using the ZCI Circuit Protected Wiring Harness Kit #119250KIT ZCI Circuit Protected Vehicle...

We installed the Eco hitch on a Model 3 in less than 4 hours in our garage. Just need a Jack pad and one hydraulic jack that gets low enough. Watch at least two of the YouTube videos, and then have fun!

The rear/higher bar adds 2 and 5/8 inches to the height of the car. That's about 58 or 58 1/2" total, but difficult to measure with the slight curve of the bar to peak in middle. Best to add 2 5/8" to vehicle spec height.

There are some useful solutions in this thread, including discussion of the new grey cable. Installed a hitch and wiring harness on my M3

In a heartbeat, best car ever. Model Y will be next though, to round out the fleet.

I didn't post originally, but am using the ZCI Circuit Protected Wiring Harness Kit #119250KIT ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit T with a small 12v battery in the trunk to power incandescent lights on a boat trailer. Pricey but...

I love my 3, but going to chime in as well as ELDA is downright dangerous, and I keep forgetting to turn it off! Received 16.2 on Friday. Had two very scare ELDA event over the weekend where the car tried to steer me into oncoming traffic. There are times when I need to drive on the...

I've had good luck with these from Murphys law, available on ebay. Sorry can't find direct link. 1/11 Tesla Model 3 Jack Pad Adapter Yellow $15.00

Fair enough, I'm sure you'll really enjoy the S!

AWD model with stock all season tires was incredible this past winter. We live in a quarter mile private driveway. Never shoveled or plowed, just punched it out of the garage and broke trail every morning. Never slipped even when scrapping the deep snow on the bottom. Also took out skiing...

Racks arrived today, two days after notification and never a tracking number. Mounted up really easily. The welds on the hook bolts are much improved with no gaps. Threads are also longer, and plastic end caps more sturdy. Worth the wait for gen 2 design.

The Portland store fedexed the plates to me in Oregon. They waited until nearly the day the temp plates expired, 3 months later, but they were very busy with deliveries in late 2018. YRMV with WA plates and less backlog.

Local and can come by tomorrow and pick it up. PM me your contact info.