hi all, i posted my woes on another thread but thought this post might be more on the nose - and perhaps if anyone else has this issue they can chime in.
My brand new baby has been at the service center over 10 days now - 1,000 miles - I've done launches (not dragstrip) before, and this time, after a single or more launches, I'd get a turtle, and the error to exit and re-enter and that may resolve the issue.
I"m wondering if it is the accellerator (i doubt it), motor (possibly), or wiring harness (i doubt it) though the SC said they were looking for pinched wires.
I can't imagine the incredible G forces necessary for a wire to pinch itself. for that matter, even at a hard launch, i don't imagine the suspension would move around that much more than say, a normal drive and hitting a pothole.
i'm also thinking it could be a thermal or a poly fuse.
i welcome any thoughts or suggestions.
My brand new baby has been at the service center over 10 days now - 1,000 miles - I've done launches (not dragstrip) before, and this time, after a single or more launches, I'd get a turtle, and the error to exit and re-enter and that may resolve the issue.
I"m wondering if it is the accellerator (i doubt it), motor (possibly), or wiring harness (i doubt it) though the SC said they were looking for pinched wires.
I can't imagine the incredible G forces necessary for a wire to pinch itself. for that matter, even at a hard launch, i don't imagine the suspension would move around that much more than say, a normal drive and hitting a pothole.
i'm also thinking it could be a thermal or a poly fuse.
i welcome any thoughts or suggestions.
