Recent content by AndreX

All MS and refresh MX beside the old model pre 2021 don't have Lin slave inside the fog light. Pre MX 2021 all use Lin bus and the slave is inside the foglight. I don't know why they changed it in the older MX, but that's the reason you can modified all MS but not older MX.

Don't they have a fuse for protection on communication lin? Btw, the car ride and work normal. My high beam somehow able to select again even without the foglight. With all those pins rearranging back and forth I might shorted both old and refresh foglights for me to test it. Like you said...

Did replacing the front foglight and sensor hardness fix the issue? I have the same problem, exterior turn signal are on but the interior car screen show no blinking and sound.

https://www.reuters.com/investigates/special-report/tesla-insurance/

https://www.reuters.com/investigates/special-report/tesla-insurance/

Anyone have any of this 2 part. Is the bracket for the fender and hood welded together. I need #8 more if you have #6, I take both.

Damn, my X somehow gave me this error object detected on top of the glass. I see nothing there and have clear or clean everything in sight. Anyone have a clue where i should look?

Reason why it's here too is alot of S wants to convert the new look but non was able to get it done. Since S and X have similarity, knowing that X works confirm that it can be work for the S except S have turn signal in the headlight. I think there's one in the X forum too about this conversion.

Correction: Old and refresh model foglight turn on when headlight and DRL are on.

Once my car come back from repairing, I will look into it. But it's more promising than zero knowledge than before. At least we know what wire or pin do what. Found out the fog light turn on with DRL at the same time for the refresh model. Since I don't have my car with me, I can't verify if...

Here's the diagram for both old and refresh model. If im not mistaken it seem the old fog light need headlight pin 5 LIN to get the foglight to work. Pin 1 and 4 vbatt is controlled by ECU (not sure if one for fog and side marker) Pin 2 Ti-Sync is turn signal and 3, 6 are ground. Refresh: All...

Did you able to see if the old board fit into the new fog light housing?

From the look of the old main board comparing to the new foglight, it looks bigger to the new fog. Let me know if you open the new foglight and if there's room, It should be easy to get it to work

Now I have the obstacle detected issue shown in yellow but I can't seem to find anything block it. Door able to close but it make a beep sound that causes the open/close button disable on the door side.