Recent content by cantchoosename

Does your current setup have data in the console or just in the glovebox? If you already have data in the console, then you don't need to run the new USB cable. When you pull out the console, you'll disconnect the existing USB cable. Basically half of it stays in the car and half of it get...

Just got my car updated. It looks like they didn’t charge me anything to update the software configuration since I already had the HEPA filter installed.

Update: the service center just updated my estimate to only $12.75 now. I told them I already had the hardware installed and this is the cost of just a software update now. Still waiting to see if they can just push it to my car remotely though

My appointment is scheduled for the 6th. I’m asking them if I can change it to a mobile service appointment instead. I already the hardware installed and just need the software updated. Hopefully they can make that part easy

Same here with 6/20 build date and retrofitted a while back. If you have any luck with getting Tesla to update your software to reflect the retrofit, please report back. I haven't tried recently, but I bombarded them with this request a while back so I'm hesitant to annoy them again.

Oh no, that sucks!! Sorry that happened! I think that’s the same tool I got on Amazon and mine worked luckily. I’m not 100% sure but you might just be able to drill out the entire rivnut and then just insert a new one (with a new tool obviously).

Honestly, it's probably fine to cut off the alignment pins. I'm not even sure why they're needed. The primary holes to mount the filter will align everything just fine and it won't move once it's tightened down. I drilled the holes for the alignment pins (and the primary mounting holes), but...

I honestly used to like reading some of the things you would post, but you have become very annoying. Please stop bickering with everyone and let the threads get back on topic.

I just download 11.3.6 the other day and took it for a drive. I was making an unprotected left turn. When the light turned green, the intersection was clear and the car could have gone twice. There was an oncoming car coming from far away and it decided to wait, so I just let it do its thing. As...

Hey James. It looks like most of the watch apps that now use bluetooth require the app to open before it can connect to the car. I just read somewhere that the Stats app created a way around this so it doesn't require the app to open on the watch first (just walk up to the car and it...

The data cable on the old console works fine. Just pull it out and connect it to the new module and route it through the bottom of the console. Then once you install the new console you’ll connect it to the other end that stays in the car.

The module on my console 1.0 was usb A ports. The 2.0 is usb C ports so it won’t fit correctly. I’m not sure exactly when they switched to usb C ports but yours are probably usb A like mine if I had to guess

I used that same Tparts module. If you have sentry data working in the center console right now then you have the data cable. It’s only for newer cars where they removed the data cable since data is wired to the glovebox usb for sentry instead. I did the install myself. You’ll be in the exact...

It seems like a lot but it’s really not bad at all and it’s a nice upgrade. The old console just feels clunky and like a big piece of plastic with those stupid lids covering the storage and phone charging. The new one seems much cleaner and sleek. Obviously personal preference but I’m really...

You will need to get a new usb module that supports data (the 2.0 console comes with a module but it doesn't have a port to connect the data cable). Other than that and the console, you will have everything that you need. All you need to do is pull the existing console out, swap out the card...